Browse by Job:
Jump To Section:
LineBacker® sealing gaskets use a rectangular sealing element, referred to as a "quad" ring, in combination with a unique groove design to effectively seal and isolate flanges of all types. With the unique quad ring design, elastic memory is provided for elastomers not normally associated with this characteristic. Materials such as PTFE may therefore be used as sealing elements, dramatically increasing the ability to match gasket materials to service conditions. This greater variety of materials also provides excellent temperature and chemical range compatibility. LineBacker® sealing gaskets are self-energizing resulting in a positive seal without excessive bolt loads - as are often required with flat gaskets.
All ANSI rated flanges to 600#/2,225 psi respectively. Maximum hydrotest pressure is 2480 psi and 302Fp>
Isolating gaskets may be specified as either "E" or "F" type while single, double or one-piece sleeve and washer sets are offered as options for varying degrees of electrical isolation between the flanges. A wide variety of material options exist for both isolating gaskets and sleeve and washer materials.
All kits are correctly sized for the application and conveniently packaged to minimize loss of component parts during installation.
Type E Gasket (Full Face) The gasket retainer extends out to the O.D. of the flange. Holes are cut at the bolt circle to accommodate threaded studs and sleeves.
Type F Gasket(Ring Type) The gasket retainer extends out to the I.D. of the bolt circle. The threaded studs and sleeves center the gasket in the flange.
Single Washer Set flange isolation kits include the following items for each threaded stud:
In buried applications, single washer configurations may be used to allow the Cathodic Protection (CP) current to reach the nuts and bolts. If desired, nuts on the opposite side of the cathodically protected flange may be included as part of the protected system.
The LineBacker® gasket is constructed from G10 glass-reinforced epoxy (GRE). The LineBacker® contains a rectangular sealing element referred to as a “quad-ring.” The quad-ring is used in combination with a unique, engineered groove design and together they provide an effective sealing element that also requires less bolt load than a typical flat gasket. The sleeves and washers offered with the LineBacker® gasket are completely temperature dependent. Most commonly used are Mylar and G10 sleeves accompanied by G10 and zinc plated steel washers. Sleeve will be designed to mate with separate isolating washers and will be of a length such that the sleeve extends into one and one-half washer thicknesses on each side of the flange.
Double washer set flange isolation kits include the following components for each bolt:
Double washer configurations may be used for added protection against the possibility of "shorting out" the nuts and bolts. In addition, double washer sets electrically isolate the nuts and bolts from both flanges.
One-piece sleeves eliminate the possibility of error by installers. One-piece sleeve and washer set flange isolation kits include the following items for each bolt:
Easier to install, one-piece sleeves also allow the inspector a visual indication of sleeve usage. Due to the relatively low compressive strength of this material, its use is not recommended for high pressure or large diameter flanges that require high torque loads.
Stay in touch with GPT through our network of sales professionals, engineering experts, manufacturing locations or distribution partners. We want to hear from you. Feel free to contact us if you have questions, big or small, we’re here to help.